Topeak Whitelite 800 Bt Handlebar Light Instruction Manual

TOPEAK WhitElite 800 BT Handlebar Light

WHITELITE 800T ( TMS 100BT) / REDUTE 80 BT (TMS101BT)

For Round Seat post / Seat stay

Mount For Aero Seat post / Seat stay Mount

For Rear Bag / Backpack Light strap Mount

Rubber strap

USB-Micro use Cable

INSTALL SEATPOST/SEATSTAY/BAG MOUNT ON LIGHT BODY

Round Seat post / Seat stay Mount

Aero Seat post / Seat stay Mount

Rear Bag / Backpack Light Strap Mount

MODE

When powering on, light reverts to last mode used

• High
• Middle
• Low
• Blinking
• Pulse

FCC

Class B: (Section 15,105)
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
• Consult the dealer or an experienced radio/ TY technician for help,

CAUTION
Any changes or medications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment
This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: 

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation,

RF EXPOSURE WARNING
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conIunction with any other antenna or transmitter, End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance,
CANADA, INDUSTRY CANADA (IC)
This device complies with Canada license-exempt RSS standard(s)
Operation is subject to the following two conditions: 

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

RADIO FREQUENCY (RF) EXPOSURE INFORMATION
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits, The Vv1reless Device should be used in such a manner such that the potential for human contact during normal operation is minimized
This device has also been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions. (antennas are greater than 20cm from a person’s body).

INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA CS-O3 STATEMENT

• This product meets the applicable Innovation, Science and Economic Development Canada technical specifications
• The Ringer Equivalence Number (REN) indicates the maximum number of devices allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices not exceed nve
• The Ringer Equivalence Number (REN) is 0.l

WARRANTY

1-year Warranty against manufacturer defects only,
(Batteries are not covered under any implied warranty.)
Warranty Claim Requirements
To obtain warranty service, you must be the original owner and provide proof of purchase. Items returned without a sales receipt will assume that the warranty begins on the date of manufacture. All warranties will be void if the product is damaged due to user crash, abuse, system alteration, modification, or used in any way not intended as described in this manual.

• The specifications and design are subject to change without notice

Please contact your To peak dealer with any questions. For USA customer service,
call: 1-800-250-3068
www.topeak.com