Breville Big Squeeze BJS700 Juicer Machine Instruction Manual

BREVILLE RECOMMENDS SAFETY FIRST

At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE

Carefully read all instructions before operating the appliance for the first time and save for future reference.
Remove and safely discard any packaging materials and promotional labels before using the
appliance for the first time.
To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the power plug of this appliance.
To protect against electrical shock, do not immerse the power cord, power plug or motor base in water or any other liquid.
Always use the appliance on a dry, level surface.
Do not use the appliance on a sink drain board.
Do not place the appliance near the edge of a bench or table during operation. Vibration
during operation may cause the appliance to move.
Do not place the appliance on or near a hot gas or electric burner, or where it could touch any other source of heat.
Unwind the power cord fully before use.
Do not allow the power cord to hang over the edge of a table or counter, touch hot surfaces or become knotted.
Always ensure the appliance is completely assembled before connecting to the power outlet and operating. The appliance will not turn on unless properly assembled. Follow the instructions provided in this book.
Always avoid contact with moving parts.
Strictly follow the care and cleaning instructions described in this book.
This appliance is for household use only. Do not use the appliance for anything other than
its intended purpose as described in this book. Do not use outdoors. Do not use in moving vehicles or boats.
The use of attachments not sold or recommended by Breville may cause fire, electric shock or injury.
Do not leave the appliance unattended when in use.
Do not operate the juice extractor without the pulp and juice container in place.
Do not use the juice extractor if the juicing screw is damaged.
Do not push produce into the feed chute with your fingers. Always use the food pusher provided.
Do not juice stone fruit unless seeds and/ or stones have been removed.
Always switch the juice extractor off after each use. Ensure the motor stops completely and
unplug the power cord from the wall outlet before attempting to move the appliance, before
cleaning, disassembling, assembling and when storing the appliance.
Do not operate the machine longer than 20 seconds before inserting ingredients.

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

Fully unwind the power cord before use.
Do not let the power cord hang over the edge of a bench or table, touch hot surfaces or become knotted.
To protect against electric shock do not immerse the power cord, power plug or appliance in water or any other liquid.
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
It is recommended to regularly inspect the appliance. To avoid a hazard do not use the appliance if power cord, power plug or appliance becomes damaged in any way. Return the entire appliance to the nearest authorised Breville Service Centre for examination and/or repair.
Any maintenance other than cleaning should be performed at an authorised Breville Service Centre.
This appliance is for household use only.
Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.
The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.

FOR HOUSEHOLD USE ONLY SAVE THESE INSTRUCTIONS

Components

A. Feeding Tube & Basket For different sizes of produce.
B. Juicing Bowl
C. Pulp Cup
D. Drum Lid
E. Detachable Smart Cap
F. Juice Jug G. Motor Body
H. Rotation Wiper
I. Strainer
J. Juicing Screw
K. Pusher
L. Cleaning Brush

Assembly

BEFORE FIRST USE
Before using your Juicer for the first time, remove any packaging material and promotional labels. Ensure the power is in the OFF position, the juicer is switched off at the power outlet and the power cord is unplugged. Wash bowl and juicing tools in warm soapy water with a soft cloth. Rinse and dry thoroughly. When first using your appliance, you may notice an odour coming from the motor. This is normal and will dissipate with use.

Firmly insert the compression silicone into the slot below the pulp spout. The Juicer may leak if not assembled properly.

Assemble the strainer into the rotation wiper then place this assembly in to the juicing bowl ensuring the red dot on the strainer is aligned with the red dot on the juicing bowl.

Place the juicing screw into the strainer. Turn and press down on it until it clicks into place.

The juicing screw needs to be locked in place in order to close the drum lid.

Place the drum lid on to the juicing bowl aligning the red dot on the drum lid with the red dot on the juicing bowl. Turn clockwise to close, aligning the red dot on the drum lid with the close mark

TIP
For easy assembly hold the drum lid by grabbing the feeding tube and turn clockwise as shown in the illustration.

Place the drum lid on the juicing bowl. Align the down arrow on the drum lid with the OPEN mark on the body and turn to the CLOSE position.

Open/Close mark on the top-set.

NOTE
The juicer will not operate if the down arrow on the drum lid is not completely aligned with the CLOSE mark on the body.
Place the pulp cup under the pulp spout and place the juice cup under the juice spout as shown in the illustration.

Operation

USING YOUR JUICER

After preparing the ingredients, plug the power cord into a wall outlet. Do not touch the power cord with wet hands. It may cause electrical shock, shortcircuit, or fire.
Press the FORWARD button to operate.

Forward: Pulls down and slowly masticates the ingredients.
Reverse: Pushes the ingredients back up to dislodge them. The REVERSE button only works while holding down the switch

Insert the prepared ingredients into the feeding tube, one piece at a time. If large quantity of ingredients are put into the feeding tube, it can cause the juicer to stop Remove hard seeds or pits in fruits. When juicing frozen fruits, completely thaw before juicing.

HARD VEGETABLES & HIGH FIBRE FOODS (E.G. CARROTS, BEETS, & SPINACH)

Insert into the feeding tube.

Tough and fibrous ingredients: Cut to 2cm wide and 5cm long.
Fibrous leafy vegetables (celery, kale, collard greens, etc.): Cut the stems into 5cm long and bundle up the leafy part as you insert them into the juicer.

SOFT FRUITS & VEGETABLES (E.G. APPLES, ORANGES & TOMATOES)

Insert into the feeding basket.

Soft ingredients: Cut ingredients into 1-4 pieces. Insert the prepared ingredients into the feeding basket and push down the ingredient with the basket lid to extract.

SMART CAP

Use the smart cap to make mixed juice, block juice from dripping, or rinse between different juices.

Juicing with the smart cap closed creates various mixed juice creations with different fruits and vegetables, milk, beans and other ingredients.
After juicing, close the smart cap to stop juice from dripping, especially when disassembling
the juicing bowl off of the base.
When making different juices, quickly rinse any left over flavors by running a glass of water in the juicer with the smart cap closed.
Leave the smart cap open when juicing ingredients that often creates foam during extraction. (e.g. apples, celery)
Pay close attention when operating with the smart cap closed. Juice may overflow if the
juice collected in the juicing bowl exceeds its capacity.

IF THE JUICER STOPS DURING OPERATION:

If the ingredients become jammed in the screw and the drum lid does not open, press the OFF button ensuring that the juicer comes to a complete stop. Then press and hold the REVERSE button until the ingredients become dislodged. Repeat REVERSE – OFF – FORWARD as often as needed to achieve the desired result. Let the juicer stop completely before using the REVERSE button to prevent malfunction.

If the juicer does not work after these steps, disassemble and clean the parts before operating the juicer again.

DISASSEMBLY

After juice and pulp have been completely extracted, switch the unit OFF.

If the remaining ingredients in the juicing bowl have not been extracted completely, the drum
lid may not open easily. (After each extraction, run the juicer for additional 30 seconds to let
the juicer extract the remaining pulp.)

When the drum lid is stuck, press the REVERSE – OFF – FORWARD button in the order, switching back and forth 2~3 times to dislodge. Then place your hands on top of the drum lid and firmly press down as you simultaneously turn the drum lid counter clockwise to open.

Depending on the ingredients, pour water down the feeding tube to rinse out the interior of the juicing bowl and then try to take off the drum lid.

Tips

Operating the juicer without ingredients can cause damage to the screw.
Do not continuously operate the juicer for more than 30 minutes. This can damage the
motor from overheating. After continuous use, let the juicer rest for 30 minutes to cool
down before starting another session.
Do not put hand, utensil, tong, or other objects into the feeding tube other than the
provided pusher.
During operation, do not put spoon, spatula or other objects into the juice spout of the
juicing bowl. If other object is put into the juice spout during operation, such materials
can get stuck and damage the juicer parts.
Do not reinsert the extracted pulp into the juicer. This can cause the juicer to stop or
cause the drum lid not to open.
After juicing ingredients with small seeds like grapes, thoroughly clean all the crevices
on the bottom of the juicing screw.

Don’ts

DO NOT PUT THE FOLLOWING INGREDIENTS INTO THE JUICER

Hard seeds
Peach, nectarines, apricot, plum, mango, etc. Remove hard seeds from the ingredients
before juicing.
Hard or inedible skins
Pineapple, melon, mango, orange, etc. Peel the skins from the ingredients before juicing.
Frozen fruits or ice
Frozen strawberry, blueberry, raspberry, etc. Completely thaw frozen fruits before juicing. Do not use ice.
Vegetable/ animal oil
Sesame seed, butter, margarine, etc.
Do not extract ingredients containing vegetable or animal oil. This can reduce performance and even damage the juicer.
Others
Coconut, sugarcane or hole grains. Do not extract ingredients with no water content.

Care & Cleaning

Extract all the remaining pulp in the juicing bowl before stopping the juicer.

For easier clean up, operate the juicer for an additional 30 seconds after the juice is extracted. Then fill the juicing bowl with water and run the juicer before opening the drum lid.

When the drum lid is stuck, press the REVERSE – OFF – FORWARD button in this order, switching back and forth 2 to 3 times to dislodge. Then place both hands on the drum lid and firmly press down while simultaneously turning the drum lid to open.

CLEANING THE JUICER

Switch OFF and unplug the power cord from the wall outlet.
Turn the drum lid counter clockwise to open.

WARNING: When moving the appliance, do not lift by grabbing the feeding tube. Always lift the appliance by grabbing the body or handle.

Turn the top-set counter clockwise and lift off the body.

Remove the juicing screw, strainer and rotation wiper unit from the juicing bowl. Clean with provided brush.

NOTE: Immediately clean the juicer after each use. If remaining residue in the juicer dries up, it can make disassembling and clean-up difficult. The excess build up can cause poor performance in future uses.

For easier disassembly, place the top-set in the sink and run the water through from the top of
the top-set.

We do not recommend to wash any parts of the juicer in the dishwasher. Washing parts in the
dishwasher can cause damage to them due to prolonged exposure to harsh detergents, hot water and pressure.

Place the juicing bowl under running water and unplug the compression silicone to clean the pulp spout.

Under running water, clean the outside of the juicing screw with a dish scrub. Use the tip of the cleaning brush to push out any residue in the crevices on the bottom of the juicing screw.

Thoroughly clean the juicing screw ensuring that the juicing screw is clean without any residue. Thoroughly dry the bottom of the juicing screw.

After juicing ingredients with seeds, make sure to thoroughly clean the bottom crevice of the juicing screw. (If this area isn’t properly cleaned, it can cause the part to be damaged.).

Clean the body with a soft damp towel and dry.

If the towel is dripping wet, make sure to squeeze out the excess liquid before using it on the juicer.

QUICK RINSING

It is not necessary to completely clean the juicer in between making multiple juices during a single juicing session. You can do a quick rinse instead.

With the smart cap closed, fill the juicing bowl with water and turn on the juicer.

Let it run for a moment. Open the smart cap and let the water run out of the juicing bowl.

When finished with juicing, always disassemble and clean thoroughly between juicing sessions to prevent residue buildup.

CLEANING SILICONE PARTS

Clean the rotation wiper under running water. Thoroughly dry after cleaning. Before assembling the top-set, ensure that the compression silicone and silicone ring are firmly inserted.

If the compression silicone and silicone ring are not firmly inserted, juice may leak from the
bottom of the juicing bowl.

COMPRESSION SILICONE

Unplug to clean. After cleaning, firmly insert into the slot below the pulp spout.

SILICONE RING

Remove the silicone ring from the juicing bowl to clean.

After cleaning, push in the silicone ring with the smaller surface facing down.

SMART CAP

Remove from the juice spout to clean. After cleaning, attach the smart cap to the smart cap silicone on the juice spout.

Troubleshooting

Breville Customer Service Centre

Australian Customers
Mail: Locked Bag 2000, Botany NSW 1455, AUSTRALIA
Phone: 1300 139 798
Fax: (02) 9700 1342
Email: [email protected] Web: www.breville.com.au

New Zealand Customers
Mail: Private Bag 94411, Botany Manukau 2163, Auckland NEW ZEALAND
Phone: 0800 273 845
Fax: 0800 288 513
Email: [email protected] Web: www.breville.co.nz

Breville Big Squeeze BJS700 Juicer Machine Instruction Manual